Setup the Profile
- Click on [Configure][Survey] and [Select from Library] for GPS+ Configuration, then [Add] a new profile
- Type in a name and choose the used Type (here we use Network RTK with VRS)
- Click [Next]
- Our rover is a Topcon product
- Click [Next]
- Set up Rover Receiver Model
- Click on [Peripherals]
- Enable mmGPS
- Click on [Parameters]
- Set port according to connection on your receiver.
- Click on the Check and Check again to confirm your setting
- Click [Next]
- The SIM is here inserted in receiver, we use the modem in the receiver.
- Alternatively you can insert SIM in controller or use Radio RTK.
- Click [Next]
- MAGNET Field uses the Advanced Communication setup. Installed modem driver (done with TRU menu [Modem Driver]) is required. Set Radio Modem to “Internal Cellular”.
- Click [Next]
- Follow the following menus like known until the end
Getting Started
- Connect to the receiver
- The transmitter symbol is colored yellow and the VRMS is within a few millimeters. Take attention to the antenna height if no dedicated mmGPS rover pole is used.
- Congratualtions, you are up and running with mmGPS using MAGNET Field