TRU (Topcon Receiver Utility): MC-R3 Connection Parameters

Steps to connect to MC-R3 receivers with TRU (Topcon Receiver Utility) to configure the GNSS board.

Log in or sign up for myTopcon to view this page:
Sign In Sign Up

TRU (Topcon Receiver Utility): MC-R3 Connection Parameters

2 0

Connecting to an MC-R3 with TRU

There are two ways to connect TRU to an MC-R3:

  • Connected to a control box (e.g. GX-55)
  • Connected to a PC via programming cable (PN 9063-1113-5).

The connection parameters vary depending on which method is used.

 

Connecting to an MC-R3 With a Control Box

Receiver Managing

  • Connect Using: Network.
  • Port Name:
    • ​Main GNSS: IP=192.168.0.100, Port=8002, Password=TPS.
    • Aux GNSS: IP=192.168.0.101, Port=8002, Password=TPS.
  • Select Connect.

Modem Managing

  • Connect Using: Network: 
  • Port Name:
    • Main: IP=192.168.0.100, Port=8002, Password=TPS.
  • Receiver Port: Internal Modem, Serial B
  • Select Connect.

Connecting to an MC-R3 With a Programming Cable

Receiver Managing

  • Connect Using: Serial.
  • Port Name:
    • ​Main GNSS: Use serial cable labeled MAIN.
    • Aux GNSS: Use serial cable labeled AUX.
  • Port Name: select the COM port of your PC.
  • Select Connect.

Modem Managing

  • Connect Using: Serial.
    • Use serial cable labeled MAIN.
  • Port Name: select the com port of your PC.
  • Receiver Port: Internal Modem, Serial B
  • Select Connect.